![]() ![]() If no further user(s) or functions are to be added, you can exit the Admin mode by pressing the CANCEL button and the drive will return to the locked standby state. The drive is now in Admin mode where Admin features can be set (e.g., adding a User.)Ħ. The GREEN LED will illuminate for one second, then replaced by the BLUE LED glowing steadily.ĥ. ![]() Re-enter that same PIN and press the button again. Enter the series of numbers that you will use for the Admin PIN and press the button.*Ĥ. ![]() The BLUE LED will glow steadily and the GREEN LED will blink.ģ. Both the BLUE and GREEN LEDs will glow steadily.Ģ. This Admin PIN can be used to set any and all of the Admin Mode Features of the drive, as well as to access its data. A 6 to 16-digit Admin PIN must first be established before the drive can be used. Quick Reference Guide for Key Command ProgrammingĬONFIGURABLE NOTE: if you are using the Aegis Configurator to set up your Aegis Padlock, or any other Apricorn secure drive, you must first ensure that the device to beĬonfigured has the “configurable” logo on the belly label and second, DO NOT perform any of the the following Manual Admin and USER PIN SETUP steps below The AegisĬonfigurator will execute these setup steps and will only recognize devices in their factory “out of box” state or devices that have been completely reset.Įach Aegis padlock 3.0 is shipped without a preset Personal Identification Number (PIN) installed on the key. Hibernating or Logging Off from the Operating System Initializing and Formatting After a Complete Reset Setting LED Flicker / Button Press Indicator Mode Setting Read-Only or Read / Write Modes from the User Mode Setting Read-Only or Read / Write Modes from Admin Mode Adding a New User PIN (Via User Forced Enrollment Mode) ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |